3 Series E46 316i (M43TU) SAL
Installation:
Shaped part for cavity bulkhead (1) must be positioned 90
°
to
plate of door pillar (2).
Then place window adhesive on shaped part for cavity bulkhead.
Fit cut cowl panel spare part and locate in position.
At connection point at top and bottom, arrange individual welding
spots so tightly as to create an enclosed seam.
Caution!
Locate welding spots in a way which prevents distortion
caused by heat elongation. Ensure that welded areas have
cooled down sufficiently.
Danger of distortion!
Weld up connecting points in door aperture.
1 = Partition area, lower cowl panel
2 = Partition area, upper cowl panel
Weld up connection point, windshield frame.
RA Replacing left or right cowl panel (partial replacement in front of roof connect
BMW AG - TIS
19.01.2013 14:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
