3 Series E46 316i (M43TU) SAL
Remove scrap metal. Clean and straighten mating surfaces.
Cut rear side wall spare part.
Measurement (A) = 235 mm from square aperture for retaining clip
of trim strip.
Measurement (A) = 140 mm from bore for entrance strip (1) with
dia. 5.5 mm.
Measurement (B) = 140 mm from bore for panel for cover on side
member (2) with dia. 9.2 mm.
Make and fit reinforcement plate for C-pillar separating point from
remaining metal sheet.
Reinforcement plate width = approx. 40 mm
RA Replacing rear left side panel (partial replacement, C-pillar)line(E46 saloon/se
BMW AG - TIS
19.01.2013 14:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
