3 Series E46 316i (M43TU) SAL
Correcting height:
Loosen nuts on hinge (1) and turn door.
Tighten nuts.
Tightening Torque,
refer to Technical Data 41 51 1AZ.
Note:
Gap must continue to run uniformly between door and sill. If
necessary, repeat previous work steps.
In case of considerable deviation, correct thickness of shim on
hinge (2).
Check door protrusion, bottom,
refer to Gap measurements, doors/hood and rear lid 41 00 ...
If you need to correct, slacken nuts on hinge (2) and move door,
bottom, out/in.
Tighten nuts.
Tightening torque,
refer to Technical Data 41 51 1AZ.
Check door protrusion, rear,
refer to Gap measurements, doors/hood and rear lid 41 00 ...
Note:
Door height: flush
When the door is closed, the closing bar must not make
contact or slip in the lock.
If you need to correct, move closing bar inwards or outwards.
Tighten down screws on closing bar.
Tightening torque,
refer to Technical Data 41 51 2AZ.
Check previous settings again and repeat work steps if necessary.
Attach cover above closing bar on C-pillar.
Then align front door,
refer to 41 51 004.
RA Adjusting left or right rear door
BMW AG - TIS
19.01.2013 14:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
