3 Series E46 316i (M43TU) SAL
Pull retaining hook as far as possible in direction of travel.
Position lever of retaining hook in center of gap in kidney.
Check retaining hook for ease of movement; correct position if
necessary.
Close hood lid slowly and make sure retaining hook does not
touch any point and that it snaps correctly into place.
Retaining hook is thus centered.
Raise hood lid.
Tighten down screws of retaining hook.
Caution!
Always check that the retaining hook is working properly!
-
Adjustment of stop screw of hood lid hinge:
Stop screw (1) set to measurement (A).
Measurement (A) = 9.5 mm.
RA Aligning hood lid
BMW AG - TIS
19.01.2013 14:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
