3 Series E46 316i (M43TU) SAL
51 11 ...
Installing/replacing license plate (without
base)
Initial fitting:
Place drilling hole template (1) on bumper (2).
Note:
Hole diameter = 2.5 mm (see template).
Drill holes according to license plate.
Remove template (1).
Secure license plate with screws provided.
Tightening torque 51 11 7AZ
.
Fit protective caps.
Repairing thread:
Drill out defective hole in bumper (2) to 9.5 mm diameter.
Insert blind rivet nut (1)*.
Secure license plate (3) with license plate screw (4)*.
Tightening torque 51 11 8AZ
.
Note:
* Sourcing reference: BMW Parts Service
RA Installing/replacing license plate (without base)
BMW AG - TIS
19.01.2013 14:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
