3 Series E46 316i (M43TU) SAL
Installation:
If necessary, replace faulty plastic nuts (1).
Installation:
Check finisher (1) for damage, replace if necessary.
Installation:
To prevent wind noises.
Check gap with a 0.05 mm feeler gauge.
Slide feeler gauge between B-pillar finishers of front and rear
doors.
When the finishers are correctly adjusted, it must be possible to
feel a slight suction resistance over the entire length of the
finisher.
If the gap is too big, this may result in wind noises.
Installation:
If necessary, release screws (1).
Press finisher (2) towards rear and tighten down screws (1).
If gap is still too big,
adjust finisher on window frame of rear door.
RA Removing and installing/replacing finisher on front door window frame, left or r
BMW AG - TIS
19.01.2013 14:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
