3 Series E46 316i (M43TU) SAL
Installation:
Trim (1) must not be damaged.
Installation:
To prevent wind noises.
Check gap with a 0.05 mm feeler gauge.
Slide feeler gauge between B-pillar finishers of front and rear
doors.
When the finishers are correctly adjusted, it must be possible to
feel a slight suction resistance over the entire length of the
finisher.
If the gap is too big, this may result in wind noises.
Installation:
If necessary, release screws (1).
Press finisher (2) towards front and tighten down screws (1).
If gap is still too big,
adjust finisher on window frame of front door.
RA Removing and installing/replacing trim on window frame of rear door (front), lef
BMW AG - TIS
19.01.2013 15:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
