bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

2 RA Removing And Installing _ Replacing The Rear (inside) Left Or Right Rocker Panel|Page 2441 > < 1 RA Removing And Installing_replacing Front (inside) Left Or Right Entrance Cover St
Page 1
background image

51 47 030

Removing and installing / replacing the rear
(inside) left or right rocker panel strip

Remove rear seat,

refer to MG 52.

Note:

For purposes of clarity, shown here without backrest side
section.

A

Lift out entrance cover strip (1) towards inside from trim (2)

of door pillar.

B

Slide entrance cover strip (1) approx. 20 mm forwards out of

clips (3) and remove.

Lever out clips (1) with pliers (head of pliers surface-ground)

Installation:

Guide (1) on bracket (2) must not be damaged.

When installing entrance cover strip, insert guide lug between
guide (1) and door seam (3).

RA  Removing and installing / replacing the rear (inside) left or right rocker panel

BMW AG - TIS

19.01.2013  15:16

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

2 RA Removing And Installing _ Replacing The Rear (inside) Left Or Right Rocker Panel|Page 2441 > < 1 RA Removing And Installing_replacing Front (inside) Left Or Right Entrance Cover St