3 Series E46 316i (M43TU) SAL
If necessary, remove front underbody protection.
Unfasten screws (3).
Release screws (1) and (2) and remove reinforcement plate.
Caution!
If necessary, insert washers at screw-down points (1)
between reinforcement plate and body, refer to Fig. R51 2824.
Installation:
Replace screws (1) and (2).
-
Install all screws
-
Tighten screws (1) and (2) to torque and then to angle of
rotation,
tightening torque, 51 71 3AZ.
-
Tighten down screws (3).
RA Removing and installing/replacing reinforcement plate on front axle support
BMW AG - TIS
19.01.2013 15:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
