3 Series E46 316i (M43TU) SAL
Version with lumbar support only:
Note:
If necessary, gently heat air hose when firmly seated.
Valve housing must not be unclipped, leakage.
If the valve housing is unclipped, release screw and clip valve
housing together.
Disconnect hoses (2) and (3) from valve housing (1).
2
Hose (blue), top cushion
3
Hose (red), bottom cushion
Note:
For purposes of clarity, shown here without valve housing.
Installation:
Observe cable guide (1) for backrest heating.
Lay air hoses (2) without kinks through hole (3).
Detach backrest cover (1) at sides towards front and remove with
support upwards from backrest frame (2).
Note:
The operation "Removing backrest cover with support" ends
here.
RA Replacing back-rest cover for left or right front seat (normal / manual)
BMW AG - TIS
19.01.2013 15:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
