3 Series E46 316i (M43TU) SAL
Release screws (1).
Installation:
Replace Taptite screws (1).
Tightening torque 52 10 16AZ
.
Release screw (2).
Tightening torque 52 10 17AZ
.
Remove seat angle adjuster (3).
Installation:
Slide left and right O-rings onto shaft. Make sure O-rings are
correctly located between seat angle adjuster and seat pan.
RA Removing and installing/replacing seat angle adjuster on left or right front sea
BMW AG - TIS
19.01.2013 15:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
