3 Series E46 316i (M43TU) SAL
Installation:
Check that sleeve (1) is firmly seated.
If sleeve (1) is loose, it must be replaced.
A sleeve (1) firmly seated in the windshield wiper arm can be
reused.
Windshield wiper arm with firmly seated sleeve (1):
Return windshield wiper system to rest position. Push wiper
arm (2) with firmly seated sleeve (1) onto shaft and tighten
down.
Observe tightening torque 61 61 10AZ
.
Check setting of wiper arm (2).
To correct setting, replace sleeve (1).
Windshield wiper arm with new sleeve (2):
Return windshield wiper system to rest position.
Push wiper arm (1) with sleeve (2) onto shaft and tighten until
hand-tight.
Set position of relevant wiper arm to rest position and then tighten
down wiper arm.
Adjustment dimensions:
Measurement 1 [mm]
Measurement 2 [mm]
24
44
RA Removing and installing/replacing both windshield wiper arms
BMW AG - TIS
19.01.2013 16:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
