3 Series E46 316i (M43TU) SAL
65 75 551
Removing and installing/replacing pitch
sensor
touring only:
Remove rear speaker on right.
Pull out cable guide (1).
Remove expansion rivet and release nuts (2).
Lift off resonance body (1) slightly.
Detach relay receptacle (2).
Disconnect plug connection (3), unclip tilt sensor (4) and
remove.
Saloon/sedan, coupé, convertible:
Release right trunk wheel arch trim in rear area.
Note:
Secure nuts (1) against falling out.
Unscrew nuts (1).
Remove holder for tilt alarm sensor (2) towards inside.
Disconnect plug.
Replacement:
Unclip tilt sensor from holder.
RA Removing and installing/replacing pitch sensor
BMW AG - TIS
19.01.2013 17:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
