3 Series E46 316i (M43TU) SAL
Release retaining screw (1) of left top belt.
Installation:
Contact surface (3) of anchor fitting (4) rests against inside of
wheel arch (2).
Tightening Torque for retaining screw (1),
refer to Technical Data 72 11 9AZ.
Note:
The seat belt can be fitted at rear left or right.
Only the position of the anchor fitting contact surfaces differs:
1.
Contact surface for mounting on left side
2.
Contact surface for mounting on right side
By way of both contact surfaces (1, 2), it is possible to fit the seat
belt on the left and right sides!
RA Removing and installing or replacing all rear seat belts (compl., with lap belt)
BMW AG - TIS
19.01.2013 17:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
