3 Series E46 316i (M43TU) SAL
Disconnect plug for ITS head airbag gas generator, refer also to
72 12 ... Unlocking/locking airbag plug connections
Slacken nut (1).
Swivel ITS head airbag gas generator to one side (2) and remove
towards rear (3).
Installation:
Replace self-locking nut.
Tightening torque, 72 12 6AZ
Installation:
The two locating lugs (1) on the ITS head airbag gas
generator must be secured in the two bores in the support
tube for instrument panel (2).
Installation:
During installation, the ITS head airbag gas generator does not
rest flush on the support tube for instrument panel; there is an
intentional gap (A).
Tightening the self-locking nut builds up a desired pretension,
which servers as additional security against release.
RA Removing and installing / replacing left or right ITS head airbag (model without
BMW AG - TIS
19.01.2013 17:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 10 -
