3 Series E46 316i (M43TU) SAL
Mark out measurements for both bores on instrument panel
support tube.
Height measurement (center bore) of lower bore:
Measurement (A) = 25 mm from lower edge of sheet metal into
which both bores are drilled.
Height measurement of upper bore:
Measurement (A) = 47 mm from lower edge of sheet metal into
which both bores are drilled.
Mark out measurements for both bores on instrument panel
support tube.
Side measurement of lower bore:
Measurement (D) = 11.0 mm from edge of sheet metal into which
both bores are drilled.
Side measurement of upper bore:
Measurement (D) = 10.5 mm from edge of sheet metal into which
both bores are drilled.
Note:
Make sure there are no lines or other equipment components
which could be damaged in the area of the marked bores.
If necessary, remove or protect existing components.
Draw off swarf when drilling.
Drill two 8.5 mm dia. bores (1, 2) at the marked points in the
instrument panel support tube.
Deburr bores and protect against rust.
RA Removing and installing / replacing left or right ITS head airbag (model without
BMW AG - TIS
19.01.2013 17:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 12 -
