3 Series E46 316i (M43TU) SAL
Remove ITS head airbag from rear grab handle bracket towards
bottom.
Important!
Do not damage the ITS head airbag in the process!
Installation:
Ensure that ITS head airbag is correctly positioned in rear
grab handle bracket.
Retaining clip (2) of rear grab handle retainer (1) must be above
ITS head airbag (3).
Important!
The retaining clip (2) must not have any sharp edges in the
area of the ITS head airbag!
Danger of damage to the ITS head airbag!
Replace bracket for rear grab handle if necessary.
Unscrew bolt (1).
Push bracket on B-pillar upwards (2).
Remove retainer, B-pillar, towards front (3).
Installation:
Tightening torque,
refer to Technical Data 72 12 3AZ
During installation, ensure that retaining lug is correctly seated
in body.
View of bracket on B-pillar
1.
Retaining bore for retaining lug of B-pillar bracket in body
2.
Retaining lug on bracket on B-pillar
must engage in mounting hole
3.
Bracket on B-pillar
4.
ITS head airbag
RA Removing and installing / replacing left or right ITS head airbag (model without
BMW AG - TIS
19.01.2013 17:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 15 -
