3 Series E46 316i (M43TU) SAL
Unclip cable holder and pull cable down slightly so that screw (1)
becomes accessible.
1.
Securing screw for retainer, A-pillar, front, of ITS head airbag
2.
A-pillar wire harness
3.
ITS head airbag
4.
Retainer, A-pillar, front
Unscrew bolt (1).
Push retainer, A-pillar, front, towards rear (2).
Remove retainer, A-pillar, towards front (3).
Installation:
Tightening torque,
refer to Technical Data 72 12 3AZ
During installation, ensure that retaining lug is correctly seated in
body.
View of retainer, A-pillar, front
1.
Retaining bore for retaining lug of retainer, A-pillar, front, in
body
2.
Retaining lug on retainer, A-pillar, front,
must engage in mounting hole
3.
Retainer, A-pillar, front
4.
ITS head airbag
Fold ITS head airbag forward so that expansion rivet is freely
accessible.
If necessary, remove cover above head of expansion rivet.
Pull out head (1) of expansion rivet (2) towards top.
Remove expansion rivet towards top.
Installation:
Replace expansion rivet.
If a cover is fitted above the head of the expansion rivet, it
must be refitted.
Replace damaged cover.
RA Removing and installing / replacing left or right ITS head airbag (model without
BMW AG - TIS
19.01.2013 17:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 17 -
