3 Series E46 316i (M43TU) SAL
Detach rubber grommet (1) and remove disconnected antenna
lead from luggage compartment.
Installation:
Make sure rubber grommet (1) is correctly seated.
Pull antenna lead up to multiband telephone antenna out of
window seal.
Carefully heat car roof in antenna area with a hot air
blower (max. 50
°
C).
Slowly lift off multiband telephone antenna (1) from rear window
with special tool 00 9 317 .
Caution!
Risk of damage!
Do not under any circumstances treat adhesive residue with
scratching, sanding or paint-dissolving materials.
Remove adhesive residue with spirit only; remove larger
residues with adhesive remover (from EPC).
Installation:
If necessary, remove adhesive coating of antenna lead (1) with
adhesive remover (from EPC).
Insert antenna lead (1) to approx. 15 cm length from center of car
with special tool 51 3 050 under window seal.
Lay remaining antenna lead (1) in window seal only after
multiband telephone antenna (2) has been stuck on.
Lay antenna lead (1) so as to avoid kinking, scuffing and
crushing.
Make sure window seal is correctly seated.
RA Replacing multiband telephone antenna
BMW AG - TIS
19.01.2013 17:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
