3 Series E46 316i (N42) SAL
11 31 005
Checking camshaft timing (N42/N46)
Special tools required:
•
11 5 120
•
11 5 150
•
11 9 190
•
11 9 270
•
11 9 291
•
11 9 292
•
11 9 293
Necessary preliminary tasks:
•
Remove cylinder head.
•
Remove all spark plugs.
Crank engine at central bolt in direction of rotation to firing TDC
position of 1st cylinder.
Inlet camshaft:
Note:
The twin surface for locating the camshaft has a curvature on its
upper side and a straight edge on its lower side.
In the firing TDC position of the 1st cylinder, the curvature on the
twin surface points upwards in the cylinder-bore axis.
Exhaust camshaft:
Note:
The twin surface for locating the camshaft has a curvature on its
upper side and a straight edge on its lower side.
In the firing TDC position of the 1st cylinder, the curvature on the
twin surface points upwards in the cylinder-bore axis.
Additional distinction of exhaust camshaft:
In the firing TDC position of the 1st cylinder, the openings (1) on
the exhaust camshaft point to the exhaust manifold.
RA Checking camshaft timing (N42/N46)
BMW AG - TIS
20.01.2013 18:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -