3 Series E46 316i (N42) SAL
Withdraw pin (3).
Remove pivot lever (4).
Remove gearshift rail (6).
Note:
There are 4 rollers at the lower end of the selector shaft (5)
and these can fall out when the selector shaft is removed.
Pull out shift shaft (5).
Position gears and shafts with front case section on special tool
23 2 400.
Unfasten screws and remove guide tube.
Note:
Two covered removal holes (1) are located on front end of
radial sealing ring.
RA Complete removal and installation of input and output shafts (S5D 200G/ 250G)
BMW AG - TIS
20.01.2013 19:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -