3 Series E46 316i (N42) TOUR
Fit special tool 11 9 350 as illustrated.
Align locating bores of sensor gears to alignment pins on special
tool 11 9 350 .
Secure sensor gears with special tool 11 9 350 .
Screw special tool 11 9 350 to cylinder head.
Slacken screw (1) of exhaust adjustment unit by a half turn.
Slacken screw (2) of inlet adjustment unit by a half turn.
Fit socket on screws (1 and 2) and tighten by hand without
play.
Pretension clamping rail by turning adjusting screw with special
tool 00 9 250 or commercially available torque wrench to
0.6 Nm.
RA Removing and installing/replacing inlet and exhaust adjustment unit (N42/N46)
BMW AG - TIS
21.01.2013 14:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -