3 Series E46 316i (N42) TOUR
Place special tool 11 9 291 on exhaust camshaft.
Turn back special tool 11 9 293 .
Hold inlet camshaft with special tool 11 9 291 so that it rests
without a gap on cylinder head.
Insert screws and tighten down special tool 11 9 291 on
cylinder head.
Tighten down special tool 11 9 293 by hand until it is supported
on special tool 11 9 292 .
Insert screw and tighten down special tool 11 9 292 on cylinder
head.
Pull oil line (1) for lubricating exhaust camshaft towards front.
Insert banjo bolt and tighten down.
RA Removing and installing/replacing intermediate levers (N42/N46)
BMW AG - TIS
21.01.2013 14:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 16 -