3 Series E46 316i (N45) SAL
![background image](/bmw/3_Series_E46/316i_N45_SAL/page-268005.png)
Bearing caps of inlet camshaft are marked E1 to E4 from inlet
side.
Lubricate inlet camshaft and bearing caps with engine oil.
Fit bearing caps of inlet camshaft.
Note:
Retaining clips (1) for oil line are fitted on bearing
caps 1 and 4.
Insert all nuts and install without play.
Tighten down nuts on bearing caps in 1/2 turn increments from
inside outwards.
Tightening torque, 11 31 1AZ
.
Fit bearing bracket (1).
RA Removing and installing/replacing inlet camshaft (N40 / N45)
BMW AG - TIS
22.01.2013 07:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -