3 Series E46 316i (N45) SAL
32 00 ...
Chassis/wheel alignment check procedure
Check adherence to test conditions
I
V
Position vehicle on measuring stand
I
V
Measure vehicle ride height
OK ->
Carry out chassis/wheel alignment
check with ride-height measurement
without load
Read off setpoint value in KDS
Tolerance -20 / +40 mm per wheel permissible
Difference between left / right max. 10 mm
permissible
Not OK / no data
I
V
Move vehicle into normal position
Introduce load and measure ride heights
Read off setpoint value in KDS
Tolerance
±
10 mm per wheel permissible
Difference between left / right max. 10 mm
permissible
Not OK ->
OK
I
V
Check suspension for damage, repair
if necessary
Move vehicle into design position
<- Not OK
Add/distribute weights and measure ride
heights
Read off setpoint value in KDS
Tolerance
±
2 mm per wheel permissible
Difference between left / right max. 2 mm
permissible
I
V
Carry out KDS chassis/wheel alignment check
with load up to design position
RA Chassis/wheel alignment check procedure
BMW AG - TIS
22.01.2013 09:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -