3 Series E46 316i (N45) SAL
33 32 ...
Replacing bearing block for front trailing arm
Special tools required:
•
33 3 280
Necessary preliminary tasks:
•
Remove rear wheel
•
Disconnect plug connection for pulse generator; if necessary,
expose lead up to trailing arm
•
Only on right side: Disconnect plug connection for brake pad
sensor; if necessary, expose lead up to trailing arm
Important!
Risk of damage!
Brake hose must not be exposed to tensile loads.
Release screw and remove bracket with brake hose.
Tightening torque 34 32 3AZ
.
Mark position of bearing block (1) to body (2) with coloured
mark (3); this simplifies subsequent toe-in adjustment.
Unfasten screws.
Tightening torque 33 32 13AZ
.
Lower workshop jack and pull trailing arm downwards.
Installation:
Check threads for damage; if necessary, repair with Helicoil thread
inserts.
RA Replacing bearing block for front trailing arm
BMW AG - TIS
22.01.2013 10:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -