3 Series E46 316i (N45) SAL
"Installation position":
Distance between mounting (1) of lock actuator (2) and outer door
plate must not exceed measurement (A).
A
< 8 mm
If measurement (A) is greater, pull mounting (1) outwards with
your finger until measurement (A) is obtained.
Insert outside handle (1).
Raised seal (2) must not be squashed by outside handle (1).
Installation:
Lever out sealing cap (1).
Tighten down adjusting screw (2) on door lock and fit sealing
cap (1).
Tightening torque, 51 22 4AZ.
Direction of rotation of adjustment screw (2):
Left rear door
Right rear door
Tighten down adjusting
screw (2) in clockwise
direction, as shown in
illustration.
Tighten down adjusting
screw (2) in
counterclockwise direction.
RA Removing and installing/replacing outside handle on left or right rear door (fro
BMW AG - TIS
22.01.2013 11:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -