3 Series E46 316i (N45) SAL
Press crimping tool together and slide contact sleeve firmly home.
Important!
Once contact sleeves have been pushed on, they should not
be detached again from the fan connector or reused.
Push on further contact sleeves for potential branching.
Installation in wet area (engine compartment, wheel arch):
Apply sealing compound on both sides and press into contacts
(1).
Fit shrink-fit hose and heat up with hot air blower (2) (approx.
250
°
C).
Note:
Ensure that fan connector has sufficient contact surface on
mounting point.
Do not heat shrink-fit hose on edges of fan connector too strongly,
risk of cracking.
Allow shrink-fit hose to cool down until hand-warm. Then press
sealing material again into contacts and onto edges of fan
connector.
If necessary, carefully heat shrink-fit hose again.
RA Installing fan connector for retrofitting/repairs
BMW AG - TIS
22.01.2013 13:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -