3 Series E46 316i (N45) SAL
86 10 ...
Removing overrunning
equipment/maintaining or replacing guide
bush/installing overrunning equipment
After installing overrunning equipment, readjust brake system,
refer to 86 10 ... Adjusting brake system
Check the guide bush while installed to ascertain whether it needs
to be replaced. Raise ball end area and replace guide bush if play
is detected in ball end area.
Note:
After installing, readjust and check brake system.
Release round head screws (1) and remove running board (2)
towards top.
Installation:
Use new self-locking nuts.
Tightening Torque,
refer to Technical Data 86 10 10AZ.
Unhook tension spring (1) from tension spring mount (2).
RA Removing overrunning equipment/maintaining or replacing guide bush/installing ov
BMW AG - TIS
22.01.2013 14:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -