3 Series E46 316ti (N45) COMP
Installation:
Bore (1) on spacer clip (2) must not be damaged.
If necessary, replace faulty spacer clip (2).
Installation:
If necessary, replace faulty clips (1) and (2) on panel (3) for rear
lid.
Replacement only:
If necessary, remove insulating mat (4).
Installation:
Pins (1) of rubber bands (2) must be correctly fitted in panel (3).
Installation:
Ends (1) of buffer stops (2) must be correctly pulled through.
Insulating strips (3) must be fitted on panel (4).
RA Removing and installing/replacing panel for rear lid (compact)
BMW AG - TIS
26.01.2013 19:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
