3 Series E46 318Ci (N46) CONVER
34 11 220
Removing and installing/replacing both front
brake disks
Remove wheels.
If necessary, remove and clean brake linings.
Caution!
If the thickness of the brake disks drops below the minimum
level (MIN TH), the disks must be replaced.
Brake disks may only be replaced in pairs (for each axle).
If the brake disks are replaced, you must also fit new brake
linings.
The brake disks of M models are tied to the direction of travel:
The uneven part number denotes the left brake disk, the even
part number the right brake disk!
Unfasten screws (1), remove brake caliper and fasten up.
Note:
Brake hose remains connected.
Installation:
Tightening torque,
refer to Technical Data 34 11 2AZ.
Unscrew bolts and take off brake disk.
Caution!
To release brake disk: Do not under any circumstances strike
friction ring with a hammer or similar! If necessary, carefully tap on
base of brake disk chamber with a rubber mallet.
Installation:
Replace brake disk retaining screw.
Thoroughly clean contact surface of wheel hub, remove
traces of corrosion if necessary.
Unevenness on contact surface may result in distortion of
brake disk!
Tightening torque,
refer to Technical Data 34 11 1AZ.
RA Removing and installing/replacing both front brake disks
BMW AG - TIS
06.02.2013 08:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -