3 Series E46 318Ci (N46) CONVER
Installation:
Pin on coupling gear must reach into bore hole on seat.
Installation:
Make sure groove and pin are correctly positioned.
Clip flex shaft (1) into place with coupling gear (2).
Ensure complete engagement by pulling gently on flex shaft. Flex
shaft must not clip out here!
Unclip flex shaft (3) from guides (1...2).
To remove flex shaft, open retainer on seat cover if necessary.
Installation:
If necessary, lock new retainers by bending with special tool
52 0 050 .
Release nut on inertia reel and remove inertia reel with flex shaft
and coupling gear.
E46: Tightening torque 72 11 17AZ
.
E64: Tightening torque 72 11 01AZ
.
RA Removing and installing/replacing front seat belt
BMW AG - TIS
06.02.2013 20:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -