3 Series E46 318i (M43TU) TOUR
Installation:
Apply Drei Bond 1209 sealing compound thinly and evenly
to the groove ends.
Seat new rubber seal in groove.
Installation:
Apply a thin coating of grease to top side of rubber profile
gasket and both sides of special tool 11 2 330 and place
special tool on gasket.
Installation:
Fit gear case cover. Insert screws and fit flush.
Carefully pull out special tool 11 2 330.
Installation:
Install cylinder head cover without seal.
Install M 6 screws with large washers and press gear case
cover down until upper edge of gear case cover and cylinder
head are aligned.
RA Removing and installing, sealing or replacing top timing case cover (M43 / M43TU
BMW AG - TIS
11.02.2013 13:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
