3 Series E46 318i (M43TU) TOUR
Installation:
Install timing case cover, insert all screws and initially tighten
to approx. 5 Nm.
Fully tighten all screws in alternate sequence.
Tightening Torque,
refer to Technical Data 11 14 1AZ.
Caution!
If all screws are tightened, they must be tightened again in a
second operation.
Replace radial seal,
refer to 11 14 141.
Note:
When using a complete seal for the top and bottom of the
timing-case cover, an attachment of the seal using special
tool 11 4 110 during the assembly of the top of the timing-
case cover is not necessary.
Assemble engine.
RA Removing and installing, sealing or replacing bottom timing case cover (M43 / M4
BMW AG - TIS
11.02.2013 13:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -