3 Series E46 318i (M43TU) TOUR
Remove bearing pin (1).
Installation:
Grease bearing pin (1).
Grease,
refer to BMW Service Operating Fluids.
Detach cable plug (1) from reverse gear switch.
Detach cable for reverse gear switch and oxygen sensor from
fixtures on transmission.
Support transmission with a workshop hoist.
Release screws.
Tightening torque, 23 00 1AZ.
Caution!
Do not allow the transmission to hang off from the
transmission input shaft as this will deform the clutch disk.
Pull out transmission towards rear and remove.
Installation:
Pay attention to guide sleeves (1 ... 2), replace if necessary.
Ensure correct position of cover plate.
RA Removing and installing transmission (S5D 200G, M43TU)
BMW AG - TIS
11.02.2013 15:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
