3 Series E46 318ti (N42) COMP
Installation:
Height of bumper is adjusted by turning hexagon socket head
screw (1) on impact absorber (2).
Installation:
After sliding in bumper, clip panel into place sideways if necessary
(by pressing gently on edge of wheel arch to center of car).
In so doing, pay attention to alignment to turn signal lamp housing.
Carry out same work in event of slight parking bumps.
Installation:
Adjust all-round gap (X) between bumper and body cutout as
uniformly as possible.
RA Removing and installing complete front bumper (compact)
BMW AG - TIS
12.02.2013 08:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
