3 Series E46 320Cd (M47TU) COUPE
Remove master brake cylinder,
refer to 34 31 500
Detach lines (1...6), seal connection bore with plugs.
V)
From THZ circuit V to ABS/ASC+T unit circuit V (front axle
circuit)
H)
From THZ circuit H to ABS/ASC+T unit circuit H (rear axle
circuit)
FR) From ABS/ASC+T unit VR to wheel brake front right
FL) From ABS/ASC+T unit VL to wheel brake front left
HR) From ABS/ASC+T unit HR to wheel brake rear right
HL) From ABS/ASC+T unit HL to wheel brake rear left
Installation:
Observe Tightening Torque,
refer to 34 32 1AZ
Unfasten plug connection (1) and disconnect.
Remove brake lines with rubber grommet from metal body and
press in direction of engine. Do not under any circumstances bend
brake lines.
Release hexagon screw (2) and remove ABS/ASC+T unit towards
top.
Installation:
Ensure that rubber grommet is correctly seated when
installing brake lines.
Installation:
Check rubber mount (1) for correct seating. Replace damaged
rubber mount.
RA Removing and installing / replacing hydraulic unit ABS/ASC+T
BMW AG - TIS
12.02.2013 17:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -