3 Series E46 320Cd (M47TU) COUPE
35 41 020
Removing and installing/replacing bracket for
accelerator pedal
Remove lower section of steering spindle,
refer to 32 31 070 .
Remove trim panel for pedal assembly.
Refer to MG 51.
If necessary, remove pedal travel sensor,
refer to MG 13.
Disconnect return spring.
Release nuts and pull holder towards interior.
Installation:
Tightening torque = 2.8 Nm.
Press down locking hook and pull accelerator pedal off holder.
Installation:
Check bearing bushings (1), replace if necessary and lightly
grease.
RA Removing and installing/replacing bracket for accelerator pedal
BMW AG - TIS
12.02.2013 17:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -