3 Series E46 320Cd (M47TU) COUPE
51 12 051
Removing and installing/replacing carrier for
rear bumper trim (M3, M3 CSL / lightweight
design)
Note:
Refer to KSD CD for details of preliminary tasks.
Important!
Foam part must be replaced when center section of bumper
(carrier) is removed.
Drill out blind rivet (1) and remove grounding cable (2).
Release plastic screws (1).
Installation:
Observe tightening torque 1.2 Nm.
Release metal screws (2).
Remove center section of bumper (carrier) (3).
Release plastic screws (1).
Installation:
Observe tightening torque 1.2 Nm.
Remove foam part (2).
RA Removing and installing/replacing carrier for rear bumper trim (M3, M3 CSL / lig
BMW AG - TIS
12.02.2013 18:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -