3 Series E46 320Ci (M54) CONVER
54 21 ...
Removing and installing/replacing fastener
for hard top at front left or right
Necessary preliminary tasks:
•
Remove roof lining.
Installation:
•
Observe hard top gap dimensions.
Release nuts (1) and screws (2).
Installation:
Tightening torque, 54 21 4AZ
.
Screws must be replaced.
By removing or adding shims, it is possible to align the hard top to
the cowl panel:
A) vertically
B) longitudinally to the vehicle
Install fastener:
-
Screw on hard top fasteners loosely.
-
Fit hard top and lock.
-
Align hard top in (A) and (B).
-
Unlock hard top and remove carefully.
-
Tighten down screws and nuts.
RA Removing and installing/replacing fastener for hard top at front left or right
BMW AG - TIS
12.02.2013 23:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
