3 Series E46 320d (M47) SAL
Disconnect plug connection from air-mass flow sensor.
Detach vacuum line from vacuum reservoir.
Release retaining elements of cylinder head cover in
sequence 22 ... 1.
Remove cylinder head cover.
Installation:
Clean gasket residue from sealing surfaces.
At transition to half-moon sections on inlet and exhaust sides,
apply a thin and uniform sealing bead of Drei Bond 1209, refer
to BMW Parts Service, approx. 2 mm high and 2 mm wide.
Installation:
Replace cylinder head cover gasket.
When fitting cylinder head cover, ensure gasket is correctly seated
on rear side of cylinder head.
RA Removing and installing/sealing cylinder head cover (M47)
BMW AG - TIS
12.02.2013 12:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -