3 Series E46 320d (M47) SAL
Make sure dowel sleeves (1) are correctly seated.
Replace seal (2).
Apply thin, uniform coat of Drei Bond 1209 sealing compound
(refer to BMW Parts Service) to edges of joint on oil pan.
Caution!
Do not use special tool 11 2 213 for the new radial seal
version.
Note:
When fitting the end cover with radial seal on the crankshaft, it
is only permitted to use the "support bushing (1) as an
installation tool.
Lubricate contact face of crankshaft.
Caution!
Push on end cover with support bushing (1) straight and
without tilting sideways.
Insert all screws and tighten down end cover.
Note:
Store the support bushing (1) of the new radial seal version
as a "special tool", then render special tool 11 2 213
unusable and dispose of.
The old and new radial seal versions can be installed with the
support bushing (1).
RA Replacing crankshaft radial seal (M47 / M57)
BMW AG - TIS
12.02.2013 12:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -