3 Series E46 320d (M47) SAL
Release screws (2 and 3) on oil-water heat exchanger.
Remove oil-water heat exchanger.
Installation:
Replace sealing ring (1).
Assemble vehicle and set down in horizontal position.
Start engine and run at idle until oil indicator lamp goes out.
Switch off engine. Wait approx. 10 minutes and check engine oil
level.
Top up engine oil if necessary.
RA Removing and installing/sealing or replacing oil-water heat exchanger (M47)
BMW AG - TIS
12.02.2013 13:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -