3 Series E46 320d (M47) SAL
Release screw on coolant connecting line.
Note:
Screw with M7 thread.
Installation:
Replace sealing ring.
Install screw and tighten down.
Tightening Torque,
refer to Technical Data 11 51 1AZ.
Disconnect charge air hose from EGR valve.
Installation:
Fit charge air hoses without grease and dry.
Unscrew bolt (1).
Pull lock (2) and detach water hose.
Remove coolant connecting line.
Installation:
Refer to general instructions for work on cooling system.
Release screws and remove water pump.
Installation:
Clean sealing faces.
Check adapter sleeves (1) for damage and correct
installation position.
Replace seal (2).
RA Removing and installing or replacing water pump (M47)
BMW AG - TIS
12.02.2013 13:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
