3 Series E46 320d (M47) SAL
Note:
The intake air manifold is vibrationally separated by rubber
mounts and seaks from the cylinder head and cylinder head
cover.
Installation:
Clean sealing faces.
Replace sealing rings (1) in intake air manifold.
Check rubber mount (2), replace if necessary.
Installation:
Fit intake air manifold.
Note:
The nuts (1) fall out very easily during removal and
installation, use special tool 00 2 190 if necessary.
Nuts (1) with M7 thread.
Screws (2) with M6 thread.
Insert nuts (1) and tighten to initial torque of approx. 10 Nm.
Insert screws (2).
-
Tighten down nuts (1).
-
Tighten down screws (2).
RA Removing and installing intake air manifold (M47)
BMW AG - TIS
12.02.2013 13:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -