3 Series E46 320d (M47) SAL
12 61 285
Replacing oil level sensor
Necessary preliminary tasks:
•
Switch off ignition
•
Unfasten oil filter cap to enable engine oil in filter to flow back
into the oil sump
•
Remove underbody panelling
•
If necessary, remove reinforcing plate
•
Drain off engine oil
Disconnect plug connection (1).
Unscrew nuts (2).
Remove oil level sensor (3).
Installation:
Clean sealing face on oil sump.
Replace seal on oil level sensor.
Installation:
Top up engine oil.
Screw on oil-filter cover tightly.
Tightening torque 11 42 2AZ
.
RA Replacing oil level sensor
BMW AG - TIS
12.02.2013 13:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
