3 Series E46 320d (M47) SAL
Release nuts on injector nozzle assemblies.
Screw special tool 13 5 250 onto injector nozzle assemblies and
remove.
Installation:
Before installing injectors, clean injector shafts.
Installation:
Injector nozzle assemblies with needle motion sensors (cable
outlet with plug) must always be fitted at cylinder 4.
Replace sealing ring on injector nozzle.
Note:
If more than 2 injector nozzles have been replaced, "Pump
map adjustment" must be carried out:
1.
Connect DIS Tester
2.
Identify car
3.
Select "Function selection"
4.
Select "Service functions"
5.
Select "Digital Diesel Electronics (DDE)"
6.
Select "Pump map adjustment"
7.
Select "Test schedule"
8.
Select "Carry out adjustment". The adjustment values are
thus set to zero.
RA Removing and installing/replacing all injector nozzles (M47)
BMW AG - TIS
12.02.2013 13:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -