3 Series E46 320d (M47) SAL
Release nuts on center bearing (1).
Tightening torque, 26 11 6AZ.
Bend propeller shaft downwards at center bearing.
Detach propeller shaft from transmission output flange and tie
back to side on vehicle underbody.
Installation:
The deflection angle of the rear propeller shaft was adjusted
in series-production assembly with the aid of washers (1).
The washers (1) are marked in the center with a colored
plastic insert and secured to the threaded pins.
When installing propeller shaft, make sure the same washers
(1) are fitted again.
Caution!
Pressure line remains connected.
Slowly relieve tension on clutch slave cylinder during removal
as otherwise air will be drawn in through sealing sleeve.
Release nuts and remove clutch slave cylinder.
Tightening torque, 21 52 5AZ.
Detach retaining clip (1).
RA Removing and installing transmission (S5D 320Z, M47)
BMW AG - TIS
12.02.2013 14:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
