3 Series E46 320d (M47) SAL
Coat rubber-coated bearing seat of center mount (2) with
Circolight.
Circolight, refer to BMW Parts Service.
Using special tool 33 3 202/ 33 3 203, press new deep-groove
ball bearing (1) into center mount (2).
Force center mount (1) onto propeller shaft (3). Collar (2) must
point to propeller shaft (3).
Drive center mount (1) firmly home with special tool 23 1 160.
Observe marking and force universal joint (1) of rear propeller
shaft onto middle propeller shaft (2).
Install screw (3) with Loctite 273 locking varnish.
Tightening Torque,
refer to Technical Data 26 11 5AZ.
RA Replacing deep-groove ball bearing in propeller shaft center mount (three-part p
BMW AG - TIS
12.02.2013 15:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -