3 Series E46 320d (M47) TOUR
25 11 101
Replacing shift rod
Necessary preliminary tasks:
•
Remove exhaust system.
•
Remove heat shield.
•
Remove transmission cross-member.
•
Unflange propeller shaft from transmission.
Detach locking clip (1).
Disconnect shift rod (2).
Installation:
Grease shift rod.
Grease, refer to BMW Service Operating Fluids.
Make sure shims (3) are in correct position.
Unlock bearing pins (1) from selector arm in direction of arrow
and remove.
Installation:
Grease bearing pin.
Grease, refer to BMW Service Operating Fluids.
Lever spring washer (1) out of groove and push a little towards
rear.
Press dowel pin (2) in direction of arrow out of shift rod joint and
remove shift rod (3).
Installation:
Grease ball of selector shaft.
Grease, refer to BMW Service Operating Fluids.
Replace spring washer (1).
RA Replacing shift rod
BMW AG - TIS
12.02.2013 16:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
